よくある質問

Common grades are AB(PRIME), ABC(SELECT), ABCD(NATURE/RUSTIC).
Check out the details of our grading standards:
PDF Oak Grading Standard
PDF American Wulnat Grading Standard

There are T&G and click. Click has a patent certificate.

View DuraMagicFloor Wood Floor Finish Introduction

1.Saw cut
①belt saw
(4-6mm above the surface board, need wet logs directly sawed and then dried. Belt saw precision is not enough, large losses, but the power is large, suitable for fast cutting wood or plate.)
②Frame saw
( the Veneer 1.8mm-6mm need kiln dry kiln dry before cutting )
2. Sliced cut
(0.4mm-3mm similar to cutting vegetables)
3. Rotary cut
(eucalyptus / birch substrate are rotated out, similar to the pen knife)

Three layers of strip engineered wood flooring, middle fir (diameter cut), bottom layer larch (sawn cut)/poplar.
Three layers of chevron engineered wood flooring can be fir in the middle and pine on the bottom.
Multilayer strips engineered wood flooring, playwood is eucalyptus (spiral cut), bottom layer is eucalyptus/birch/beech.

The plywood of the three-layer is usually pine, which is a soft wood that easily absorbs moisture from the air. If the top layer is too thin, after a long time, the plywood absorbs moisture, and the top layer will have waves, which is obvious in sunshine. Therefore, the veneer of three-layer engineered wood flooring can not be less than 3mm.

The metals we use are brass and stainless steel.

The color is brass, natural stainless steel.

The wood flooring cannot be inlaid with all kinds of metal plating. Because particular required metal shades/colors/coats, such as “Rose Gold / Silver / Bronze,” are all surface layers and can not be sanded. If you can’t sand it, you can’t fix the Thickness. Before we can paint parquet wood flooring, it must be sanded to determine the Thickness.

Our square Parquet (tiles with metal) finish is Flat and native color. If you do color, the color of the paint will cover the metal. So it can only be the original color.

Yes, The engineered floor are all available for heating system.

The moisture content of engineered floor is normally 8+-2%,We use moisture tester. We do moisture test from the beginning to the end of production many times. When we are selecting veneers, after kiln dry, after gluing, and after coating before packing, we check the moisture all the time. And not only to the veneer, but also to the plywood. Only if the veneer and plywood moisture has reach a certain value, we can start glue and cold press.

The norm is 8%+-2%. For different markets, each market moisture content is not the same. The general moisture content of Europe, Central Europe, such as Germany, Austria is around 6%. If it’s France or Spain, it’s a little higher near the sea. 8-10%.
Dubai, the Middle East and Australia have water content of 9%. South-east Asian countries can expect 11-13%.